Hi gang, new to the site so I hope I'm posting in the correct place. I'm looking to purchase a bore guide for a new Accuracy International AT308, can someone steer me in the right direction please?
Accuracy International Bore Guide
- Thread starter flati
- Start date
Mike Lucas all the way but not sure if he is still making guides.
If you go that route, be patient as well
If you go that route, be patient as well
For me one of the better ones. Yes, he does them in batches so yes patience. He did one a few months agar
for me.
for me.
I use one of the ProShot bore guides, cheap, set it where you want, and gets the job done.
The Lucas snaps into place and will not move around. Mike makes the best bore guides available - I have one for each of my rifles and sized for the specific cleaning rod I use.
I actually have a Dewey bore guide that was used on my Remington 700, will that work?
Yes, they are all pretty basic. I use the same bore guide on my AX and custom actions.
The rifle is not here yet but I was under the impression that it would be too loose of a fit inside of the action, that's good news then.
