So after putting a couple rounds down range earlier today I noticed the butt pad that's attached to the metal bar was becoming loose. I checked the clamping acres on the right side of the stock. Both are still really right. Upon further inspection I see it's the actual bit road is loose on the metal bar. By this time it's loosened WAYYYY up. I can't seem to find anyway to remove the rear most rubber pad to get in there and tighten anything.
I've only had this stock sense Christmas, and has exactly 59 rounds shot through it. So if anyone has had this problem, and can give me a solution I would be appreciative!
I've only had this stock sense Christmas, and has exactly 59 rounds shot through it. So if anyone has had this problem, and can give me a solution I would be appreciative!