I have a 95 AW. I like the 1.0 skins but would like to try the viper skins or the new AI skins. I am not sure if AI is making them for a 1.0. Could someone send or post pictures and measurements of the hole spacings. I have a machinist friend who says it should be no problem as long as he knows where to put the holes. I have removed my skins. There are no holes for mine to be updated by adding helicoils for the thumbscrews or holes for the check rest. Any help is appreciated.
Gunsmithing AI AW 1.0 to 1.5
- Thread starter Jrb572
- Start date
Re: AI AW 1.0 to 1.5
Off topic but I have a friend that might be interested in those 1.0 skins if you're gonna sell them.
Off topic but I have a friend that might be interested in those 1.0 skins if you're gonna sell them.
Re: AI AW 1.0 to 1.5
First hole is 5.8235" to the center from the back of the receiver.
Holes are 1.808" CTC and measure .247" dia.
Cheek piece pins are .235" dia.
Mine is a 2.0 so, I don't know if that would change anything.
First hole is 5.8235" to the center from the back of the receiver.
Holes are 1.808" CTC and measure .247" dia.
Cheek piece pins are .235" dia.
Mine is a 2.0 so, I don't know if that would change anything.
Re: AI AW 1.0 to 1.5
Have you located the cheekpiece you'll need? Or do you need the smith to fabricate that as well?
Have you located the cheekpiece you'll need? Or do you need the smith to fabricate that as well?
Similar threads
