Anyone know of spinner/reactive plates for 22LR that are 6-10 inches?

[TheGerman]

Basically looking for this:

https://www.amazon.com/Champion-22-...8&qid=1536288878&sr=1-38&keywords=22lr+target

But in a 6 inch, 8 inch, 10 inch version.

I need something thin for rimfire as it'll be shot at 250, 300+ yards so it can't be AR500 that will not even move when hit. Anyone know of any?

 

[Hoser]

1/4 inch AR-400 will work perfect.

 

[steelbanger]

1/4 inch AR-400 will work perfect.

Does that pronghorn know he is in the middle of a rifle range?!

 

[MarkCZ]

Basically looking for this:

https://www.amazon.com/Champion-22-...8&qid=1536288878&sr=1-38&keywords=22lr+target

But in a 6 inch, 8 inch, 10 inch version.

I need something thin for rimfire as it'll be shot at 250, 300+ yards so it can't be AR500 that will not even move when hit. Anyone know of any?

Shootingtarget7 has 22lr steel gongs https://shootingtargets7.com/22lr-t...MIxevq-JKq3QIVBl6GCh2STQx0EAAYASAEEgIdJ_D_BwE also I have KYL from Bluegrass targets. https://bluegrasstargetsky.com/coll...cts/know-your-limits-upgraded-complete-system

Mark

 

[Fig]

I wouldn’t pay for a “target” for that, and there is NO WAY it would be AR500. 1/8th cut steel isn’t going to scratch from .22 at that range...for certain. Just by some square scraps and grind them round if you must, or just hang them. You will not hurt it and save hundreds... unless money is no object....

 

[Dai Bando]

AR500 is cheap, sounds good and aint gonna pit up or bend.

I'd love for JC Steel to make slotted hook 1/4" IPSC targets scaled down for rimfire.....

 

[Hoser]

Does that pronghorn know he is in the middle of a rifle range?!

He does. He just ignores us. After a while he wonders off.

 

[JS624]

Check out D-M steel targets.

 

[TheGerman]

I wouldn’t pay for a “target” for that, and there is NO WAY it would be AR500. 1/8th cut steel isn’t going to scratch from .22 at that range...for certain. Just by some square scraps and grind them round if you must, or just hang them. You will not hurt it and save hundreds... unless money is no object....

So I grabbed 2 from the shooting targets website but can use them on a hangar setup I already have, so that was only 20$, but whatever.

I did call my friend who fabricates and builds Jeeps and custom off road vehicles and asked him about scrap steel and would he make a target. He's already trying to troll me with making a 8 inch plate, yet cutting parts out of it to make a cross, and then have it be able to slightly spin if the wind hits it.