Autotrickler V2 Fine Powder

warnera1102

Sergeant of the Hide
Full Member
Minuteman
Feb 25, 2020
357
184
I am running an autotrickler with the Lee powder dump (V2) and it does not like fine powder such as BLC-2.
Have you guys seen this issue before? It leaks out the side and if i adjust the wheel to much it will cause the motor to skip. I dont have issues on larger granular powders.
 
I am running an autotrickler with the Lee powder dump (V2) and it does not like fine powder such as BLC-2.
Have you guys seen this issue before? It leaks out the side and if i adjust the wheel to much it will cause the motor to skip. I dont have issues on larger granular powders.
Yes, when I had my V2 it would lockup on CFE223. I would only use it for stick powder after that. You could always get a manual powder drop and use that. Works great that way.
 
I am running an autotrickler with the Lee powder dump (V2) and it does not like fine powder such as BLC-2.
Have you guys seen this issue before? It leaks out the side and if i adjust the wheel to much it will cause the motor to skip. I dont have issues on larger granular powders.
Thats the only issue with the v2, ball powders. The v3 corrected that issue while keeping the same general design, but is no longer available.
 
  • Like
Reactions: warnera1102