I finally received my (remington footprint) BAT short repeater action today for my 6.5x47 build. I dropped it into my AI stock and both the action screws for the stock were roughly 1/8 of an inch too far to the rear of the stock. Is this common? Will all Dave and Jared (APA) have to do is mill out the rear of the recoil lug cavity so the action will sit farther back allowing alignment? If so, I assume this can be done precisely allowing full lug contact and action screw alignment? I had a rem. 5R in this stock previously that dropped in perfect with no mods. Thanks for the help