A previous memeber posted a thread for an adjustable buttstock he made for his boyds tacticool. Seeing as he is in Australia and per ITAR regulations it would cost quite a bit for him to sell them to the US guys i decided to go ahead and get my own made.
Havent finished the blueprint quite yet then its off to my machinist to get it quoted. My friend(10/22), my brother(marlin), and myself(marlin) all have boyds tacticool so I will have 1-3 made initially and go from there.
It will be made out of aluminum and probably a steel rod. I would like to have scribe marks ever 15 degrees as well at every .250" but i dont think the shop has a laser marker. You would need to drill a 1/2" hole in your stock after you use your existing wood screws to bolt it to the stock. The buttplate will be held in place with 8-32 SHCS.
I took off the height adjustment due to the fact it cannot be used in NRA light rifle. But it wouldnt be to hard to add it back in almost like the marlin 2000 buttstock as seen in the bottom picture.
Comments, suggestions, questions?
Havent finished the blueprint quite yet then its off to my machinist to get it quoted. My friend(10/22), my brother(marlin), and myself(marlin) all have boyds tacticool so I will have 1-3 made initially and go from there.
It will be made out of aluminum and probably a steel rod. I would like to have scribe marks ever 15 degrees as well at every .250" but i dont think the shop has a laser marker. You would need to drill a 1/2" hole in your stock after you use your existing wood screws to bolt it to the stock. The buttplate will be held in place with 8-32 SHCS.
I took off the height adjustment due to the fact it cannot be used in NRA light rifle. But it wouldnt be to hard to add it back in almost like the marlin 2000 buttstock as seen in the bottom picture.
Comments, suggestions, questions?
