For the past several months I have taken a family friends 14yo daughter under my wing and have been helping her learn / train for PRS. She shot one match end of last October with my gear and was instantly hooked. I was asked to build her a rifle on a VERY tight budget that her parents and grandparents were going to give her for Christmas. She has been shooting it for a couple months in an ongoing state of build, not knowing it was actually to be her rifle come Christmas.
Started off with a $400 Varmint barrel 700ADL 6.5CM. Trued the action, reworked the barrel tenon on the OE barrel and replaced the recoil lug, set the barrel back 1 turn and recut the chamber with my match reamer. Got a cheap used Oryx chassis, and coated the plastics in her favorite blue, skim bedded the action in marine tex. Installed the Oryx ARCA rail and machined the front of the chassis to accept an MPA spigot. Was able to get a cheap Triggertech special on Black Friday. set to 1.5lb. Machined a bolt knob from some scrap 6061 bar stock. Burris XTRii 5-25 SCR mil bought close out at a deep discount mounted in a set of Vortex/Seekins "refurbished" rings. Silencerco ACR mount / brake so she can run one of my cans, only likes to shoot suppressed.
Today was the 1st trip to the range with the fully completed rifle and she impressed me with her skill with such a low cost build. We were testing some new loads at 100y, doing some chrono testing and hit a great node despite being a touch on the slow side, 140's @2710. She managed a 5 shot group at .3 moa, followed up with 5 more to the same spot opening the group up to just a touch over .4 moa. So a 14yo girl with only 6 months of shooting experience managed a 10 shot .4 moa group with a slightly reworked OE Remington barrel. I don't think I have ever seen a factory Remmy barrel shoot this well and she was able to hold it there for a 10 shot string. I truly believe there are great things in her future! Unfortunately I did not get any target or rifle pics, phone battery died.
Started off with a $400 Varmint barrel 700ADL 6.5CM. Trued the action, reworked the barrel tenon on the OE barrel and replaced the recoil lug, set the barrel back 1 turn and recut the chamber with my match reamer. Got a cheap used Oryx chassis, and coated the plastics in her favorite blue, skim bedded the action in marine tex. Installed the Oryx ARCA rail and machined the front of the chassis to accept an MPA spigot. Was able to get a cheap Triggertech special on Black Friday. set to 1.5lb. Machined a bolt knob from some scrap 6061 bar stock. Burris XTRii 5-25 SCR mil bought close out at a deep discount mounted in a set of Vortex/Seekins "refurbished" rings. Silencerco ACR mount / brake so she can run one of my cans, only likes to shoot suppressed.
Today was the 1st trip to the range with the fully completed rifle and she impressed me with her skill with such a low cost build. We were testing some new loads at 100y, doing some chrono testing and hit a great node despite being a touch on the slow side, 140's @2710. She managed a 5 shot group at .3 moa, followed up with 5 more to the same spot opening the group up to just a touch over .4 moa. So a 14yo girl with only 6 months of shooting experience managed a 10 shot .4 moa group with a slightly reworked OE Remington barrel. I don't think I have ever seen a factory Remmy barrel shoot this well and she was able to hold it there for a 10 shot string. I truly believe there are great things in her future! Unfortunately I did not get any target or rifle pics, phone battery died.
Last edited: