I was recently gifted a what seems to be very expensive BRASS one piece cleaning rod. I am not accustomed to this i usually just use a rubber coated dewey rod. What do y'all know about a brass rod? good or bad? should i use it or stick to rubber?
Gunsmithing Brass cleaning rod
- Thread starter Duffy1298
- Start date
Re: Brass cleaning rod
I believe the brass could eventually have some foreign object embedded in it,that may scratch the barrel. Personally, I would stick to a coated Dewey one piece rod or the like with a good bore guide. That's my $0.02
I believe the brass could eventually have some foreign object embedded in it,that may scratch the barrel. Personally, I would stick to a coated Dewey one piece rod or the like with a good bore guide. That's my $0.02
Re: Brass cleaning rod
rubber coated is MORE likely to get something embedded than brass... brass rods are fine
rubber coated is MORE likely to get something embedded than brass... brass rods are fine
Re: Brass cleaning rod
well i have two of the exact opposite responses. i guess i should flip a coin
well i have two of the exact opposite responses. i guess i should flip a coin
Re: Brass cleaning rod
but force multiplier your response makes more sense as brass if more dense than rubber.
but force multiplier your response makes more sense as brass if more dense than rubber.
Re: Brass cleaning rod
Doesn't matter. I would not hesitate to use a good brass rod if I had one. However all the "good" rods I use now are Dewey.
Doesn't matter. I would not hesitate to use a good brass rod if I had one. However all the "good" rods I use now are Dewey.
Similar threads
