Rifle Scopes Bushnell LRHS Zero Stop Issue

[generalzip]

Looking to get some help on this. I got my scope zero’d On my rifle. I think pulled the cap off, loosened the set screws and set the zero stop. When I went to put the cap back on it will not allow me to align it with 0. It will go on +-.1 mil but not exactly at zero. It appears the teeth on the turret are too course and will only allow you to align it in increments of .2 mils. Has anyon else experienced this? I searched high and low and haven’t seen any posts about this issue. Thanks in advance.

 

[BobinNC]

Contact Bushnell. Here's a partial e-mail sent to a user on another site:

Just wanted to touch base with you. With the early LRHS optics and several of the Elite Tactical’s they used a 50 spline turret, which could cause issues with the turret seating/locking in true .1 mil increments. We have an order of 100 spline turrets on the way, but I haven’t heard yet from my parts manager if they’ve been checked in yet. To get the ball rolling though if you want to reply to this email with a good address I’ll get a parts order started so that once the new 100 splines turrets get checked in we can get one out to you ASAP.

All best,

Dan Merrick
Service Technician
Dealer Services
Bushnell Holdings, Inc."

 

[generalzip]

You the man. Thanks. I’ll shoot them an email. The parallax knob is backwards too, but that’s not a huge deal

 

[spife7980]

Yep, issue with the early model ones on the half spline. My lrtsi has the backwards parallax too, it’s not major because I don’t go by the numbers when I adjust it but when I first get in the rifle it sucks having no reference to where it’s already at. Again, minor like you said but death by a thousand pricks... I did replace my swaro with it though