I'm looking for any load info about this bullet https://cuttingedgebullets.com/cgi-bin/commerce.cgi?preadd=action&key=MTH_L04 I would like to use it with my .375 CT, barrel is a Krieger 30" twist 1:10.
Thanks
Thanks
Cutting edge .375 MTH_L04
- Thread starter one shot ST
- Start date
Contact Will Ross with Center Shot Training, he has been working with Cutting Edge, and their 350 grainers for a while. Best
With my rifle I have used the MTH L10 which is the 350gn pill not the 320gn pill. It gets the same velocity as the 350gn SMK, with 1.5gn less powder (Retumbo). So you may be able to use that as a guide to work up a load with the MTH L04.
The L10 gets 3130fps with 133gn Retumbo in my rifle and is the max load that I tried with this projectile although pressure was fine. Accuracy was excellent.
The L10 gets 3130fps with 133gn Retumbo in my rifle and is the max load that I tried with this projectile although pressure was fine. Accuracy was excellent.
thanks for replay, I'm using the MTH L04 because is the only one do not require single feed, are you using a mag ?
No I don't use a magazine.
I run a Stiller single shot 408 action. With the L10, I have the seal tite band just touching the case mouth.
shooting a cutting edge 320 gr, only 980 meters, I've to found yet a good load, at 100 m the groups is not so good 1,5 MOA, SMK 350 5 shots in one hole, but a 908 meters the vertical stringing of the cutting edge is good..
video, in the center trace visible
CT 320 gr on the target
video
video, in the center trace visible
CT 320 gr on the target
video
