What i the preferred scope for ELR shooting. We shot 1 mile on friday and my Hensoldt 4-16 on a 20 moa base left me 13 mils of elevation from a 100 zero. My SB 5-25 on the same rifle left me w 11 mils. I needed about 19.5 total mils w the load i was shooting. I guess i could add a Spuhr 10 moa mount or buy a NF. My buddy ran a NF and was able to dial up w the turret.
-
Having trouble using the site?
Contact support
ELR Scope
- Thread starter BCX
- Start date
you're gonna want more elevation in the rail and mount. I think im somewhere around 27mil with my razor gen 2. 20moa base and 20moa spuhr
something with 30+ mils of elevation adjustment plus 30-40moa of rail/mount puts you in a good spot until you start needing an era-tac adjustable
something with 30+ mils of elevation adjustment plus 30-40moa of rail/mount puts you in a good spot until you start needing an era-tac adjustable
On my AI-PSR it has 30 moa in the rail and after I zeroed at 100 yards I still have 28.8 of the total 34 mils in my 3x27 S&B. You need to add at least 20 moa in a base or rail.
you can zero at 100 with a S&B 5-25 rocking a 44.4 moa / 13 mil sphur mount its about as perfect as you can get.
Like the marine corp style ones? https://www.eurooptic.com/schmidt-bender-pmii-5-25x56-l-p-p4-fine-mrad-mtc-ccw.aspx You'd probably be either dead on or have .5mils to spare my 5-25 with 26 mils on a 40 moa rail zero'd at 4.6 from the factory my trg with 44.4moa sphur zero'd a S&B 5-25 with 26 mils exactly 1 mil above factory zero
6.5 Prc 147/150 going 3110 maybe 3200 fingers crossed next batch for testing. I tried 1 mile for the hell of it w factory 147 held a good group just could never dial it on target even w hold over on reticle due to wet conditions and fog. This handloads I believe needs 16.5-17 mils for 1 mile w 100 yard zero.
Well maybe if you had a 7 saum with a nightforce you would have gotten there no problem
LMFAO maybe just maybe i will buy a NF if the 28 NOSLER comes.Well maybe if you had a 7 saum with a nightforce you would have gotten there no problem
This is what you need
https://www.eurooptic.com/era-tac-a...-37mm-146-high-with-quick-release-levers.aspx
https://www.eurooptic.com/era-tac-a...-37mm-146-high-with-quick-release-levers.aspx
I use about 18-20 power going out to a mile with my 50 and 338
The problem you will run into and some guys here may disagree but.... When going further distances, you are using a bigger caliber which means more recoil. After I take my shot, I like the place the reticle back on where my point of aim was before the round impacts. If it's a miss, then I know about how much I missed (left right up or down) If I am zoomed way in, it is really hard to get back on target because of the tight FOV and the low clarity at higher powers. I use a K624i with SKMR3 reticle
The problem you will run into and some guys here may disagree but.... When going further distances, you are using a bigger caliber which means more recoil. After I take my shot, I like the place the reticle back on where my point of aim was before the round impacts. If it's a miss, then I know about how much I missed (left right up or down) If I am zoomed way in, it is really hard to get back on target because of the tight FOV and the low clarity at higher powers. I use a K624i with SKMR3 reticle
This is why I'm a firm believer in Christmas tree type reticles in ELR scopes. No matter how much mechanical elevation you have, if you shoot far enough, you are going to max it out and then some.
That's why I chose the Khales K624i with AMR reticle on my .300NM. Scope doesn't have the most elevation, but the reticle is about perfect for ELR shooting, and you can always pair it with a Charlie TARAC if you really want to shoot far with it.
That's why I chose the Khales K624i with AMR reticle on my .300NM. Scope doesn't have the most elevation, but the reticle is about perfect for ELR shooting, and you can always pair it with a Charlie TARAC if you really want to shoot far with it.
I'm in the middle of building a 375 cheytec imp. with a goal of 1 to 2 miles with it out here in AZ. What scopes would you guys recommend considering for this build?
A S&B 3-27 High Power w/34mils of elevation or a NF beast in a 60 moa mount will get you there.
This could be the new hotness..... http://marchoptics.com/shop/brand_march-optics/firstfocalplane/6-60x56mm-scope
Been dealing with this myself. In your case, an option would be the Steiner M5xi 3-15x50 with TReMoR2 reticle: 52 mils of total internal travel with 26 mils on the turret, then an additional 38 mils on the tree reticle for a grand total of 64 mils. Depending on your target, the 15x should be enough given the tendency for heavy mirage down there. I've been keen to take a whack at that setup, but the Steiner can't take the cold up here. I can go to a mile with a straight 10x easy on standard IPSC target, and any caliber for that range don't need more than like 19 mils or so, so in warm air at altitude you should be easy to 2 miles as long as the mag range works.
I've looked at that March scope. I haven't found anything on the internet since it first came out. Plus the price has gone up $900 since earlier in the year, which pretty much makes it out of my price range.
Yeah, I'm looking for an ELR scope too. March sent me an update on the Genesis scope. The price is up where a NF, a Charlie Tarac and a Spuhr mount would cost. The March is about 9-10OZ lighter. Since the whole scope moves instead of the reticle it should optically clearer but.... would you end up staring down at the end of a 38" barrel when shooting out to 2 + miles...??
Choosing the March for a dedicated ELR combo, if you can afford it, would seem to be a simple solution but going for the SB or NF and Charlie Tarac combo will still give you the advantage of using your scope for other disciplines of shooting like PRS, Another advantage is you have more choices for reticles...
Choosing the March for a dedicated ELR combo, if you can afford it, would seem to be a simple solution but going for the SB or NF and Charlie Tarac combo will still give you the advantage of using your scope for other disciplines of shooting like PRS, Another advantage is you have more choices for reticles...
Take a look at the M7xi, Steiner bills it’s temp range -40 to 64 c. Not sure if they’re in the wild yet, but would fit your needs.
Where are you in the bush? You’re pic looks like somewhere on the Yukon. If you ever make it into Anchorage there’s a growing contingent of us here. Also some good guys up in Fairbanks we shoot with occasionally.
I'm thinking I'll probably figure out the scope and get the rifle going with whichever one I choose. 30 mills should get me close to 1.5 miles then save up for the Charlie Tarac. Rifle is being built with a Bat L 2" round, 38" Bartlien 5r 1 in 7 twist. Barrel and XLR BMG Chassis.
So will this to be a 416 Barrett necked down to .375"?
BTW-Just remember if you go with a newly released scope and use a Charlie TARAC that they make an adapter to fit it.
Chambering will be an improved cheytec case for around 100fps gain over the standard cheytec.
My other elr rifle has a Kahles 624i on it. But I would prefer a little more magnification on this rifle. I can always dial it down but be able to turn it up when conditions allow.
We ran two 375 Snipetacs - Improved 375 Cheytac with 4.5-27x56 Gen II Razor MRADs with 80 moa rails this covered everything from 100 yards out to 3000 +
We also had a Hot Rod 375 pushing a 400 gr Flat Line at easy 3361 fps with the Gen II Razor MRAD running a 50 moa setting on a lockable base that could cover the same.
With your set up if you get something in a 40 moa rail it will cover what your 6.5s capable of.
Good Luck
Oneshot.
We also had a Hot Rod 375 pushing a 400 gr Flat Line at easy 3361 fps with the Gen II Razor MRAD running a 50 moa setting on a lockable base that could cover the same.
With your set up if you get something in a 40 moa rail it will cover what your 6.5s capable of.
Good Luck
Oneshot.
Have a 50moa rail on order from Bat Machine that should get to the smith in a few weeks.
Anyone know anything about the Trijicon accupower 5-50 scopes? Supposed to have a 100 moa vertical adjustment and I think they have a mil version.
Recently took delivery of my first dedicated ELR rig, a 338 Lapua Improved. It has a 40 MOA base, and it's going to be a bit before I purchase a new scope. I am strongly leaning towards taking my 4.5x27 Razor off of a .223 Trainer and putting it on the Lapua.
My other options in swapping scopes around would be a 5.5 x 22 NXS sfp, or a 4.5 x 30 Athlon EtR.
Since I just had to return a broken Athlon BTR that was on a 300 WM for about 500 rounds to the manufacturer, I'll probably put the Athlon on the trainer with much less recoil.
Thoughts?
My other options in swapping scopes around would be a 5.5 x 22 NXS sfp, or a 4.5 x 30 Athlon EtR.
Since I just had to return a broken Athlon BTR that was on a 300 WM for about 500 rounds to the manufacturer, I'll probably put the Athlon on the trainer with much less recoil.
Thoughts?
Similar to the Delta. Mil version is in .05 mrad clicks. The Delta is in .1 mrad.
