Hi everyone.
I have bought two forster bump dies, 6.5 Creedmoor and 6 Creedmoor.
The bushing is adjusted with a little float inside as in the manual.
If i adjust the die to the shellholder as pr manual im missing 2-3 mm of travle before the nect is fully sized, there is no way to get the die low enough over the case to actually bump it.
I control the bump using the Wilsons case gauge.
Does anyone else have this issue. ?
I have had a shellhoulder turned down to absolut minimum and that has allowed me to bump the 6.5. But the 6, needs to go every lower.
Would it even be possible to take off the Die or is the steel hardend.
https://www.forsterproducts.com/pro...ing/bushing-bump-neck-bench-rest-sizing-dies/
I have bought two forster bump dies, 6.5 Creedmoor and 6 Creedmoor.
The bushing is adjusted with a little float inside as in the manual.
If i adjust the die to the shellholder as pr manual im missing 2-3 mm of travle before the nect is fully sized, there is no way to get the die low enough over the case to actually bump it.
I control the bump using the Wilsons case gauge.
Does anyone else have this issue. ?
I have had a shellhoulder turned down to absolut minimum and that has allowed me to bump the 6.5. But the 6, needs to go every lower.
Would it even be possible to take off the Die or is the steel hardend.
https://www.forsterproducts.com/pro...ing/bushing-bump-neck-bench-rest-sizing-dies/