• Online Training Rescheduled: Join Us Next Week And Get 25% Off Access

    Use code FRIDAY25 and SATURDAY25 to get 25% off access to Frank’s online training. Want a better deal? Subscribe to get 50% off.

    Get Access Subscribe

Greenhill formula problems (???)

garrett

Private
Full Member
Minuteman
Oct 1, 2007
0
0
Seattle, WA
So I just acquired a Remy 700 sps tac in .223 with a 1:9 twist and I have been reading up on bullet "behavior" and when trying to use the greenhill formula to calculate what length of bullet is most acceptable for this twist and velocity and I am coming up with a bullet length of about 1.006" and then some. Which roughly translates to about an 80 grain bullet in .224 diameter. Most people recommend a bullet way below this weight, around mid 60s for a 1:9 twist right? How can I reconcile these two opinions? Or am I just doing the math wrong!
smile.gif


My specs are...

bullet diameter = .224
bullet velocity = 2500 - 2700 (to begin working up)
SG = 10.9 (lead core)
Twist rate = 9.0
"C" = 150 or 180

and bullet length = unknown

any input would be appreciated!
smile.gif
 
Re: Greenhill formula problems (???)

You will most likely be able to shoot 75 grain bullets out of that rifle just fine. I have the exact rifle and I shoot Hornady 75 gr. BTHP match bullets 1/2 moa at 100 yards. I could not get the 75 gr. A-max to shoot well. They are a longer bullet. I do not think you will get anything longer than a 75 A-max to stabilize. Try the 70 gr. berger vld bullets. They are nice. Also try the 75 grain bullets from Hornady to see how they do.
 
You must be at least 18 years of age to use this site
You confirm that you are at least 18 years of age by continuing to use the site.