Rifle Scopes Has anyone used this combination?

[Slowmaro02]

I picked up a bushmaster ba-50. The scope mount i would like to use is a larue lt107 that has 30 minutes of slope built in. The scope is a vortex viper pst gen II 5-25x50. Will i be able to zero at 100 yards or will the scope run out of adjustment? I need a qd mount because it wont fit in the case. Any suggestions?

 

[ken226]

That scope, according to Vortex website, has 70 moa of total elevation travel.

You should be able to zero and have 5moa to spare, assuming the barrel is pointing the same direction as the receiver.

If anything is out of square, that 5moa of leeway can get eaten up pretty fast.

 

[wade2big]

It will be tight. Vortex PST gen ii have poor internal adjustment ranges compared to every other scope in its class that I am aware of.

 

[Shawn1492]

You don’t need a QD mount you need a ne case.

 

[Slowmaro02]

Any recommendations on some 20moa mounts non qd?

 

[beetroot]

Should be ok I'd think, I have zeroed both my 5-25 and 3-15's 40meters on my 22lr with 35 and 45moa respectively.

The 3-15 with 45moa is about 3clicks up from the bottom. I use a rail and then Burris signature see rings which allows me to fine tune the can't should I need it.