Rifle Scopes High scope mount needed.

338LM_Sniper

Full Member
Supporter
Full Member
Minuteman
    Anyone know of a good scope mount that is around 1.8” height with zero MOA slope? My Accuracy International AX50 has a really high cheek riser and using a 1.5” high mount is too low for proper eye placement.

    I really like the Spuhr SP-4024 mount but nobody has the older version with both rings having 6 screws, I really don’t like the SP-4024C version.

    Any suggestions on a High Mount that has 6 screws per ring with zero MOA slope and atleast 1.7” high? It’s got to be able to take the blast from a 50 BMG.

    Thanks for you input.
     
    I was looking for a Spuhr SP6004 for similar reasons, pickings are slim from what ive found. ERATAC does make a 0 moa 1.89" in 34 and 36mm i.d. that might work for you. No experience with them but they're German made and says right on their website tested for 50 cal.
    They're 4 screw rings though so maybe not. Hope you find something that works.
     
    Anyone know of a good scope mount that is around 1.8” height with zero MOA slope? My Accuracy International AX50 has a really high cheek riser and using a 1.5” high mount is too low for proper eye placement.

    I really like the Spuhr SP-4024 mount but nobody has the older version with both rings having 6 screws, I really don’t like the SP-4024C version.

    Any suggestions on a High Mount that has 6 screws per ring with zero MOA slope and atleast 1.7” high? It’s got to be able to take the blast from a 50 BMG.

    Thanks for you input.
    When back in stock, this might help, and be less expensive than a new mount:


    -Stan
     
    • Like
    Reactions: DanUSMC