The photos are of the set up I use in the house. The Radio is a Kenwood TS 2000 which to me is almost the swiss army knife of Ham Radios.
Tuner is a Ameriton ATR20, Amp a Ameriton AL80B, Power supply a Astron VS35m, Hex rotating via CDE & Ham IV. Antenna switch a Alpha Delta 4 feeding a fullwave + 80meter loop, 1/2 wave 80 meter NVIS, Hex Beam for 20 to 10 and a dedicated 60 meter CF dipole. The 2 meter 1.25 & 440 are on a J-pole up at 40AGL. The speakers on the left are the HF side, the right side is the sub side (2meters & down) Mic is a Heil PR781 & The CW paddle is a bencher.
Digital interface is a Signal link USB feeding an off camera laptop. Don't have to use the tuner much at all as most all antennas are either 1-1 or less then 3-1 on the freqs I use most, but its there just in case. (When using the amp I make sure its 1-1 prior to keying up). The HF Portables are all Kenwood as will, but stay in a F-cage unless being used. Main HT is Yeasu VX6R but have many UV5R fangs that are used for training FNG's. PTT peddle is on the floor. The bench below is where I also load plus do electronic tinkering, so I can multi task.
What type gear you guys running?
Tuner is a Ameriton ATR20, Amp a Ameriton AL80B, Power supply a Astron VS35m, Hex rotating via CDE & Ham IV. Antenna switch a Alpha Delta 4 feeding a fullwave + 80meter loop, 1/2 wave 80 meter NVIS, Hex Beam for 20 to 10 and a dedicated 60 meter CF dipole. The 2 meter 1.25 & 440 are on a J-pole up at 40AGL. The speakers on the left are the HF side, the right side is the sub side (2meters & down) Mic is a Heil PR781 & The CW paddle is a bencher.
Digital interface is a Signal link USB feeding an off camera laptop. Don't have to use the tuner much at all as most all antennas are either 1-1 or less then 3-1 on the freqs I use most, but its there just in case. (When using the amp I make sure its 1-1 prior to keying up). The HF Portables are all Kenwood as will, but stay in a F-cage unless being used. Main HT is Yeasu VX6R but have many UV5R fangs that are used for training FNG's. PTT peddle is on the floor. The bench below is where I also load plus do electronic tinkering, so I can multi task.
What type gear you guys running?
Attachments
Last edited: