Title changed to avoid some nasty ax confusion LOL
I ordered a rear tang for my Kidd rifle from Kidd. I have a Boyd’s ProVarmint it is in now. I have asked around some NC based forums for a smith to inlet the stock for the tang but have not been given any suggestions.
The front action screw area is well done with a steel bedding block and pillar, just need the rear inletted and bedded.
Anyone know a good smith in central NC, Raleigh or close?
If I choose to try it myself, would my drill press and the Kidd recommended 1/2” end mill do a decent job?
I ordered a rear tang for my Kidd rifle from Kidd. I have a Boyd’s ProVarmint it is in now. I have asked around some NC based forums for a smith to inlet the stock for the tang but have not been given any suggestions.
The front action screw area is well done with a steel bedding block and pillar, just need the rear inletted and bedded.
Anyone know a good smith in central NC, Raleigh or close?
If I choose to try it myself, would my drill press and the Kidd recommended 1/2” end mill do a decent job?
Last edited: