LC LR PULL DOWN BRASS
- Thread starter GONE BAD
- Start date
Yep! The nail polish remover worked.
I can't believe the use that CRAP!
I thought I cut a fat hog but been a real pain trying to get this brass in shap. Probably have to punch the primers too.
Oh well, still should end up with brand new LC LR brass.
Thanks for the help.
Actually didn't know they used that kind of sealent.
It's got to be on once fired brass also?
That would be a bitch to remove from a barrel?
I can't believe the use that CRAP!
I thought I cut a fat hog but been a real pain trying to get this brass in shap. Probably have to punch the primers too.
Oh well, still should end up with brand new LC LR brass.
Thanks for the help.
Actually didn't know they used that kind of sealent.
It's got to be on once fired brass also?
That would be a bitch to remove from a barrel?
Yeah, acetone is about the only thing that will touch that military bullet sealant. I chucked up a bore brush I'd dipped in acetone and scrubbed it out that way, then came back with the cotton swabs to get any residue.
You can get Lake City Long Range cleaned brass directly from Brass Bombers. The long range brass does not have a crimped primer.
You can try calling or email them for additional info. I bought some and was very satisfied. Friendly and helpful bunch of folks as well!
You can try calling or email them for additional info. I bought some and was very satisfied. Friendly and helpful bunch of folks as well!
