Holy cow, what a nice tool. I am pissed off I waited so long to get this tool now. Set up takes two minutes, can do 20 cases per minute, with a twist after the cutting is done the trim is perfectly cut to length.
-
Having trouble using the site?
Contact support
Little Crow case trimmer, what a time saver.
- Thread starter ArmyJerry
- Start date
Yes, just clean out the case bushing part ever couple hundred rounds. Get it you wont be sorry, I just used mine to trim a thousand cases of 308. will do 4 or 5 thousand 223 tomorrow.
Agreed, they are great for bulk reloading. I wouldn't shoot my AR's if I didnt have this bad boy!
WFT. True words. I use mine in a drill press. Awesome!
If Little Crow is listening... could you make a cutter that trims, chamfers, and de-burrs all in one step?
If Little Crow is listening... could you make a cutter that trims, chamfers, and de-burrs all in one step?
+1 on the trimmers. I bought 4 of them for every caliber I mainly shoot. They are ridiculously fast and accurate. I think I had +_ .001" difference at most. Plus the deburring aspect rocks
Use mine in a drill press for 308 (and all 308 based loads), 6.8 SPC, 223, and one more (forget which one it is). I do have to pull it from the press every now and again to empty the trimmer. If I used a hand drill (like the WFT was designed for), I do not think I would have to clean it out.
Great tool!!!
Great tool!!!
great to hear more good things about this trimmer. I've been wanting to get one but have bit of difficulty justifying the $70 to trim just one cal. Granted right now I only shoot .223 and 6.5 creed.
Time is money. Trust us, it's worth every penny! Get one for whichever cartridge you reload more.
It forced my Wilson into semi-retirement.
What impressed me the most was the consistent trim length.
What impressed me the most was the consistent trim length.
Yeah unbelievable huh, I get a brush and brush out the bushing every 100 rounds or so, I also do a half twist when I feel the cutters stop cutting, I found this to leave the absolute smoothest edges and easier to chamfer, this thing is dead on accurate.
