Gunsmithing Milling out Remington 700 feed rails
- Thread starter dakor
- Start date
Re: Milling out Remington 700 feed rails
Ive never had a problem, I did a surgeon 1086 the other day. It didnt need a lot but a 300 ultra mag case was wider in the back-end then the feed rails were.
Ive never had a problem, I did a surgeon 1086 the other day. It didnt need a lot but a 300 ultra mag case was wider in the back-end then the feed rails were.
Re: Milling out Remington 700 feed rails
A few stokes with a diamond file will have it working in no time. Just don't get greedy or the action is toast.
A few stokes with a diamond file will have it working in no time. Just don't get greedy or the action is toast.
Re: Milling out Remington 700 feed rails
Make sure you get the Ultra mag box. I changed a .257 weatherby LSS to a 300 RUM and didn't have to mess with the rails.
Make sure you get the Ultra mag box. I changed a .257 weatherby LSS to a 300 RUM and didn't have to mess with the rails.
Re: Milling out Remington 700 feed rails
Thanks guys. Some of the actions I have that are standard magnum will fit the case some will not. This action is newer and the case will not fit through there. I will open up the rails and I am also going to install the biggest mag box Wyatt makes so I will need to mill out the receiver for that.
Thanks guys. Some of the actions I have that are standard magnum will fit the case some will not. This action is newer and the case will not fit through there. I will open up the rails and I am also going to install the biggest mag box Wyatt makes so I will need to mill out the receiver for that.
