• Having trouble using the site?

    Contact support
  • You Should Now Be Receiving Emails!

    The email issued mentioned earlier this week is now fixed! You may also have received previous emails that were meant to be sent over the last few days - apologies, this was a one time issue and shouldn't happen again!

Maggie’s Motivational Pic Thread v2.0 - - New Rules - See Post #1

IMG_3779.jpg
 
the inside is 4"+ in depth and I need a small radius if I where to use a .75 em it would have to be 5 times D , that em no matter how slow you go will chatter and be mega expensive . and if I edm the inside I get yet another big block of alum out of it instead of turning it into chips
I do that deep with a standard 3/4 reduced shank EM frequently, no chatter. But I get it with the extra block. Good luck.
 
how do you guys like my billet aluminum gun case , can fit at least 3 pistols in it
planning on machining it soon . middle section will be wire cut out using edm
it will have an o ring around the top lip to keep it nice and sealed up

Can you make one that you put a MP5K inside and then are able to fire it, while still in the case, via a trigger on the handle?
 
TxMsk.png


 

Attachments

  • 1614823608766.png
    1614823608766.png
    1.6 MB · Views: 50
View attachment 7572474

If only it were true. The reality is that a business can still require it. I believe in Texas a mayor can do this as well as a county judge. Someone correct me if I’m wrong. Austinites will still be wearing 27 masks to walk their chihuahua-poodle cross breeds