Rifle Scopes Mpa 1.06 dloc mount on kahles

[bjay]

Can someone verify/confirm if kahles 6-24 or 5-25 clear the erector using this combo..photos would be nice too..
Tnx

 

[Lc17smp]

I have a Kahles 525 mounted on a MPA Comp chassis with a MPA 1.125 mount. Here is a pic of it. Im guessing it won't fit but don't have the tools to check it at home.

 

[bjay]

I have a Kahles 525 mounted on a MPA Comp chassis with a MPA 1.125 mount. Here is a pic of it. Im guessing it won't fit but don't have the tools to check it at home.

So you think the 1.06" wont clear erector housing?

 

[Lc17smp]

If I'm understanding the question correctly I don't believe it will. I tried to slide a dime between the mount and bottom of the scope and it wasn't even close. Not a chance it would fit. Google says a dime is .053in.

 

[M338]

The website says 1.125 for the 6-24 Kahles,they have the same height listed for nightforce I have tried the 1.060 and it would not work, bottomed out on the rail.

 

[bjay]

The website says 1.125 for the 6-24 Kahles,they have the same height listed for nightforce I have tried the 1.060 and it would not work, bottomed out on the rail.

Danget! Just purchased one i guess it will for sell soons as i received it

 

[M338]

Yeah it hurts man,I did the same thing!To be honest the 1.125 is a bit higher than I want to be,I’m just going back to 2 piece rings.

 

[bjay]

Yeah it hurts man,I did the same thing!To be honest the 1.125 is a bit higher than I want to be,I’m just going back to 2 piece rings.

I saw post that spuhr 1.10 clears it