Rifle Scopes MPA Rifle + M24 barrel + Vortex Razor Gen2 = What Rings?

[6xcKY]

Help me with that math question! New rifle on the way, MPA Curtis Axiom with M24 6mm barrel. Don't like a high cheek weld, wanting best rings at the right height and low clearance.

 

[Fig]

https://www.snipershide.com/shooting/threads/ring-height-info-how-to-measure-correctly.20706/

First figure out exactly how high, and then choose the rings. Use the search feature. There are hundreds of threads and plenty of good advice.

 

[6xcKY]

https://www.snipershide.com/shooting/threads/ring-height-info-how-to-measure-correctly.20706/

First figure out exactly how high, and then choose the rings. Use the search feature. There are hundreds of threads and plenty of good advice.

Oh I know how to measure, I just wanted to go ahead and order some while the rifle is being shipped as well so everything arrives together.

I typically use the 8541 Tactical method, stacking pennies and measuring with a caliper LOL

Just wanted to see what the other MPA guys with same set up was using real quickly so I could place an order given the same action/rail and contour setup.

 

[strike33]

I used ARC mediums with my Razor Gen 2 and MTU barrel, still fit AAD caps and Defender caps

 

[702lineman]

If your not running caps 1in or low rings will be close depending on brand of barrel. If your going to run caps they need to be the next size higher. This is if your running a 20moa rail

 

[502Chevelle]

Just call Phil at MPA and run one of their mounts. Super solid, and he will be able to tell you the exact one that you need.

 

[levi8599]

I run an M24 contour barrel and with base and caps I went 1” seekins. The .92 would’ve worked without caps. I go as low as possible.

 

[jpspeeddemon]

Nightforce Ultralight mediums would work for sure. The lows may cut it too close with the MTU profile. I use lows on my Tiikka CTR w/ a Athlon Cronus and there is less than 1/8" clearance.

 

[Rebelirons]

I would imagine any ring 1” or higher. I have 1” Seekins with a Gen 2 Razor with the exact set up and I have plenty of room for caps. 1” tube center to rail top

 

[Togeneral99]

Go here

https://masterpiecearms.com/shop/mpa-ba-bolt-action-mount/

They tell you exactly which mount size to get.

I run a similar combo and went with the 1.125” mount and there was around 0.050” clearance to the mount and plenty of room to the barrel