New guy here! I'm choosing my preferred factory load for my 6mm Creedmoor 26" and I'm stumped choosing between a low MV SD or a higher SD but faster MV and better BC.
On the one hand, I have Federal Premium with a 105gr Berger (.275 G7 BC) that's shooting an average of 3050 fps with an SD of 10. (One thing I noticed with this load was that closing the bolt took a bit more force than usual, and same with opening the bolt and ejecting the case. Not sure if that's an issue.)
On the other hand, I have the Barnes 112gr match burners (.3 G7 BC) that were shooting an average of 3094 fps with an SD of about 20.
Both grouped about the same, so I can't tell if I should go for the Federal ammo that has a lower BC and lower MV, but more consistent MV or the Barnes that was faster with a better BC, but less consistent MV.
Use case is PRS matches and long range hunting coyotes/pronghorn.
Which load would you run?
On the one hand, I have Federal Premium with a 105gr Berger (.275 G7 BC) that's shooting an average of 3050 fps with an SD of 10. (One thing I noticed with this load was that closing the bolt took a bit more force than usual, and same with opening the bolt and ejecting the case. Not sure if that's an issue.)
On the other hand, I have the Barnes 112gr match burners (.3 G7 BC) that were shooting an average of 3094 fps with an SD of about 20.
Both grouped about the same, so I can't tell if I should go for the Federal ammo that has a lower BC and lower MV, but more consistent MV or the Barnes that was faster with a better BC, but less consistent MV.
Use case is PRS matches and long range hunting coyotes/pronghorn.
Which load would you run?