First off, the gun started out as a basic Remington 700 SPS-V in .22-250. I put a Buckmasters 4.5-14X40 on it with Warne rings and a Harris bipod.
I then upgraded to a B&C Medalist Tactical A3. With this stock, the gun shot very well but it needed more. This is where LongRifles Inc came into the picture. I originally was just going to have the stock painted and the barreled action cerakoted to match. During the process of this, Chad called me up and said that they were running a group buy for the bolt to be fluted and a tactical knob installed. So I said why not.
The stock is painted in Coyote Tan, White, and Black. They call it Wasteland Holographic.
Prepaint:
Painted:
The next few pictures show how the bedding block was resurfaced.
Now here is the proof. Remember I am no crack shot. Before LongRifles worked on my gun, I could hold about a 4 inch group at 300 yards. Now with the same reloads, my group size has shrunk to under 3 inches. After the cold bore shot, my groups are under 2 inches @ 300 yards. The upper left shot is my cold bore shot. Now I really need some trigger time to shrink these groups since I know the gun can do it now.
Loads are: 33.6 gr Benchmark
Nosler 55gr BT
CCI 200 primers
Ogive= 2.000
If anyone is needing any custom work,gunsmithing, or even have any questions I highly recommend Chad Dixon and LongRifles Inc. Throughout the whole process, I talked with at lease 3 of their employees about the process that they are doing. Each and everyone were very thorough and knowledgeable.
The turn around time for my gun from the day I shipped it out to the day I received it back was 10 days.
Facebook Page:
https://www.facebook.com/pages/Longrifles-Inc/405264722901625?fref=ts
Web address:
LongRifles, Inc.
I then upgraded to a B&C Medalist Tactical A3. With this stock, the gun shot very well but it needed more. This is where LongRifles Inc came into the picture. I originally was just going to have the stock painted and the barreled action cerakoted to match. During the process of this, Chad called me up and said that they were running a group buy for the bolt to be fluted and a tactical knob installed. So I said why not.
The stock is painted in Coyote Tan, White, and Black. They call it Wasteland Holographic.
Prepaint:
Painted:
The next few pictures show how the bedding block was resurfaced.
Now here is the proof. Remember I am no crack shot. Before LongRifles worked on my gun, I could hold about a 4 inch group at 300 yards. Now with the same reloads, my group size has shrunk to under 3 inches. After the cold bore shot, my groups are under 2 inches @ 300 yards. The upper left shot is my cold bore shot. Now I really need some trigger time to shrink these groups since I know the gun can do it now.
Loads are: 33.6 gr Benchmark
Nosler 55gr BT
CCI 200 primers
Ogive= 2.000
If anyone is needing any custom work,gunsmithing, or even have any questions I highly recommend Chad Dixon and LongRifles Inc. Throughout the whole process, I talked with at lease 3 of their employees about the process that they are doing. Each and everyone were very thorough and knowledgeable.
The turn around time for my gun from the day I shipped it out to the day I received it back was 10 days.
Facebook Page:
https://www.facebook.com/pages/Longrifles-Inc/405264722901625?fref=ts
Web address:
LongRifles, Inc.
