Rifle Scopes Need help with a 20MOA Mount

[shoot4fun]

I have a TC Icon in 6.5CM that shoots great. SO far it is turning in 1/2 MOA performance with factory ammo.
I have ordered a XLR chassis for it that should be in soon. Also had a trigger tuned up by a gunsmith that will fall under 2 1/2 pounds.
Now, the issue. These actions have integral pic mounts (only the Warlord had 20 MOA built in) so I need either 20MOA rings or a one piece 20MOA ring mount. I've looked at the AadMount and the NF unimount but they won't span across the bridge and sit on the integral mount of the rifle. The total length is 5.5" from very front of the base to the very back. There is a 3" clean space between the two base sections.
I am looking for suggestions on where to get a mount that will do the job. Any ideas?

 

[jasonk]

Re: Need help with a 20MOA Mount

Only thing I can think of is that Barrett makes 20moa rings, not sure if there's a specific spacing they need to maintain though.

Option #2 - Call Richard Near of Near Manufacturing and I'll be he could make anything happen.

 

[MitchK]

Re: Need help with a 20MOA Mount

You could use the Burris Signature rings with eccentric inserts.

http://www.burrisoptics.com/sigrings1.html#2

 

[shoot4fun]

Re: Need help with a 20MOA Mount

Yea. I saw where Barrett makes the rings.
I am thinking Richard may be the best option. Or Cameron at Murphy precision.

 

[shoot4fun]

Re: Need help with a 20MOA Mount

I use Burris Signature Zee rings a lot but haven't used them on a tactical build.
That would definitely be the least expensive route.

 

[shoot4fun]

Re: Need help with a 20MOA Mount

I thought a Badger Riser Rail might work but Marty says no.
The Barrett ring option is starting to look better.
Any more ideas?