Need help with trigger identification/twist rate

[Tackman11]

Hi All,

I just picked up a 700 Sendero 300WM at local gun shop one of those trade in and I have few question about it.

1. Is this original trigger? if it's not then what type?
2. How do I adjust the trigger pull.
3. What's the twist of the barrel(26")lenght?

Thanks all and have a nice Holiday.

 

[PCR]

Re: Need help with trigger identification/twist rate

That's a jewel trigger. Nice score. How much did you pay for the rifle?

 

[Tackman11]

Re: Need help with trigger identification/twist rate

Thanks PCR,

How do i adjust trigger pull?

$750 with the brake installed and bedded. The guy said he put less than 100 rounds down the pipe.

 

[PCR]

Re: Need help with trigger identification/twist rate

Got any pictures of the whole rifle? again... nice score!

Jewel trigger adjustment

http://www.ada.ru/guns/remington/jewell/manual_en.htm

 

[Tackman11]

Re: Need help with trigger identification/twist rate

Here she is:

 

[Badshot308]

Re: Need help with trigger identification/twist rate

Sounds like you got a really good deal. Your twist is probably 1 in 10, but the way to determine that is to run a cleaning rod with a snug patch down the bore. Go slow and measure how many inches it takes to make one complete revolution. Just use a piece of masking tape as a flag on the rod, about 14" out from your bore guide and watch as it rotates.

 

[red6actual]

Re: Need help with trigger identification/twist rate

The set screw in the center of the trigger (the part you pull to fire) will adjust the trigger pull weight, turn clockwise or screw in for heavier and CCW or out for lighter, anything else you need to have a triggersmith do it unless you have know what you are doing.

 

[Tackman11]

Re: Need help with trigger identification/twist rate

Thanks all. I'll try it out