Howdy, i have just recieved my new McMillan A5, Thanks heaps to JW Precision for the help, where great people to deal with.
Now i installed the stock the other day and tightened the bolts up fairly tight, and noticed that the bolt handle wont drop the entire way down into the little channel on the stock.
If i loosen the screws off a little bit then the bolt handle drops down and i can cycle the bolt freely and easily.
What would be causing this problem? And is there a solution?
and
Is it bad to have the bottom screws loosened off a tad or do they need to be as tight as possible?
Now i installed the stock the other day and tightened the bolts up fairly tight, and noticed that the bolt handle wont drop the entire way down into the little channel on the stock.
If i loosen the screws off a little bit then the bolt handle drops down and i can cycle the bolt freely and easily.
What would be causing this problem? And is there a solution?
and
Is it bad to have the bottom screws loosened off a tad or do they need to be as tight as possible?