I was just wondering if it's possible to do a one-day load development.
Plateform: Aero Percision Solus
Caliber: 6mm CM
Barrel: 26in Sendero (100 rounds through)
Bullet: 108 gr ELDM
Brass: New Alpha OCD LRP
Powder: H4350
Primer: CCI #200 LRP
1- (Powder Charge test)Load up 1 or 3 rounds each from 39.2gr-41/42gr or in .2 increments seated .03 from Jam 2.810" (seated at 2.780"") (10rounds vs 30 rounds vs 60 rounds)
*Once the node is found only shoot that node group and save the rest for something else or reuse it to re-test seating depth once the group changes to retune.
2- (Bullet Seat test) Load an additional 3x3 rounds from the powder charge test seating .03 (2.750", 2.720",2.690") 120 Rounds vs 180 rounds)
The only reason for this one-day load development is that the range is 1.5hr away without traffic and 2.5hr-3hr with traffic. I'm trying to make the most with time and money. They cost almost the same if I were to do 2 trips vs 1 trip and loading extra for seating depth so the only thing is I'm losing time. The only way I lose is if the range for the seating node isn't enough.
Any assistance is much appreciated.
Plateform: Aero Percision Solus
Caliber: 6mm CM
Barrel: 26in Sendero (100 rounds through)
Bullet: 108 gr ELDM
Brass: New Alpha OCD LRP
Powder: H4350
Primer: CCI #200 LRP
1- (Powder Charge test)Load up 1 or 3 rounds each from 39.2gr-41/42gr or in .2 increments seated .03 from Jam 2.810" (seated at 2.780"") (10rounds vs 30 rounds vs 60 rounds)
*Once the node is found only shoot that node group and save the rest for something else or reuse it to re-test seating depth once the group changes to retune.
2- (Bullet Seat test) Load an additional 3x3 rounds from the powder charge test seating .03 (2.750", 2.720",2.690") 120 Rounds vs 180 rounds)
The only reason for this one-day load development is that the range is 1.5hr away without traffic and 2.5hr-3hr with traffic. I'm trying to make the most with time and money. They cost almost the same if I were to do 2 trips vs 1 trip and loading extra for seating depth so the only thing is I'm losing time. The only way I lose is if the range for the seating node isn't enough.
Any assistance is much appreciated.