All the BS is about over, thank heavens.
When it is over I police up a bunch of the signs to use for target holders.
I go after the ones made of the plastic cardboard.
The large ones are good for backers on frames and the smaller ones with the H wires are good too.
With the small ones I take the wire out of one and poke it in down close to the bottom of another one so you have 4 points to steady it, shoot it up then change the plastic out and go again.
It takes 2 of the H wires to stabilize them enough.
Poke the second one in a few inches from the bottom and stick em in the ground. Kind of an A frame configuration.
You can't beat the cost. Regards, FM
When it is over I police up a bunch of the signs to use for target holders.
I go after the ones made of the plastic cardboard.
The large ones are good for backers on frames and the smaller ones with the H wires are good too.
With the small ones I take the wire out of one and poke it in down close to the bottom of another one so you have 4 points to steady it, shoot it up then change the plastic out and go again.
It takes 2 of the H wires to stabilize them enough.
Poke the second one in a few inches from the bottom and stick em in the ground. Kind of an A frame configuration.
You can't beat the cost. Regards, FM