Press mounted 3 way brass trimmer ??

[The Knuckle]

Has anyone rigged a 3 cutter on a press? Or maybe a trimmer then a chamfer next to it.

Trying to think of a way to get all my brass prep on the press. Chamfer is done by hand.

 

[RegionRat]

A while back... can't remember how far back, maybe two three years... a fellow on the forums was playing with motorizing a Lee chamfer die in a set-up for Dillon and other progressives.

He was trying to gage interest in making and selling copies of his rig, but he didn't get much interest and then he went quiet.
It was too bad cause I think he was on to something useful.

 

[Maurygold]

Has anyone rigged a 3 cutter on a press? Or maybe a trimmer then a chamfer next to it.

Trying to think of a way to get all my brass prep on the press. Chamfer is done by hand.

id just buy a giraud before you ruin a bunch of brass. if you have dexterity issues - then the Henderson

 

[TheOfficeT-Rex]

A few years ago I considered a honey badger based setup (and I think you could bodge a three way trimmer on there).

Honestly, a henderson (or giraud, if that's your preference) is going to be cheaper and less hassle.

 

[The Knuckle]

I thought maybe someone modified a Dillon trimmer or something else but I have a Henderson in my cart. Just would be pretty nice if it was mounted to a press eliminating another step

 

[Maurygold]

nope. few guys were playing with amp mates on the giraud a few years ago but that doesn't seemed to have culminated to anything stable.

 

[biggershooter]

Has anyone rigged a 3 cutter on a press? Or maybe a trimmer then a chamfer next to it.

Trying to think of a way to get all my brass prep on the press. Chamfer is done by hand.

Deluxe Power Quick Trim

Trim, chamfer and deburr the inside and outside of case necks in a matter of seconds. Hex shank snaps in to cordless screwdriver or drill (sold separately). Includes power Quick Trim adapter, chip catcher, and deluxe cutter assembly. To complete your trimming setup, order cartridge specific...

leeprecision.com

Works fine on a progressive. I run it with a powered screwdriver, if you need to raise the screwdrive to clear other dies just use an extension.

 

[The Knuckle]

Awesome, I thought someone had to have done this.