Gunsmithing PTG/M5 Iinlet in a B&C A5

[acebanana]

Just wondering if anyone has done the inletting for the PTG bottom metal (M5 inlet) on a B&C A5 stock, and if so did you have to remove material for the back portion to fit under the trigger finger? Reason I ask is because due to the depth of that back spot it seems like it would suck doing that with a dremel. The rest doesn't look bad but that deep spot at the back would be the only thing stopping me from doing it myself...

 

[2156SMK]

You will need to both widen and deepen the trigger guard area for the m5 bottom metal to fit into the original bdl inlet.

 

[Goathead1096]

I inletted the non adjustable BC,and it was quite a pain. The bedding block takes some time to open up, and material needs to removed everywhere that the bottom metal touches the stock.