SOLD RRS TFCT-33 Anvil-30

[Mudflap621]

As new RRS TFCT-33 with Anvil-30. This is NOT the new ARC Anvil. I cannot find a scratch on it. It was just a tad too short for me so ended up going with the 22i. $1450 shipped/insured via PP FF, can also do a bank check.

 

[Saf3sh00t3r]

@ksanoski

 

[FJBPrecision]

awesome setup! same one I have now, finally found me that anvil30 I was looking for

good luck with the sale

 

[Mr. F]

Removed

 

[ShotgunDiesel]

awesome setup! same one I have now, finally found me that anvil30 I was looking for

good luck with the sale

Are they too short to spot off of with binos? Seems like 60” is too low.

 

[Mudflap621]

Depends on your height. Im 5'11" and it was a tad short for me with bino's attached directly to the anvil. I do have a small 6" carbon extension that I originally ran on top of the anvil and that gave me more than enough height. I can include that in sale as well.

 

[Mudflap621]

Pending Funds

 

[FJBPrecision]

Are they too short to spot off of with binos? Seems like 60” is too low.

For me I’m 5’-9” and I have no problem spotting. I run the binos and spotter on a grayops elite plate on top of the anvil 30.

Works great for me but I could see being a touch taller may not be tall enough

 

[Jefe's Dope]

Are they too short to spot off of with binos? Seems like 60” is too low.

I'm 5'8" and they are perfect for spotting when fully extended. One of two reasons I purchased this exact setup. The other was three sections vs. four. I felt it would be more stable and reliable with one less section. You give up a shorter overall length when collapsed but the overall weight is less.

 

[Rutter]

Did this sell, if not I’ve got the funds for it.

 

[Mudflap621]

It’s pending funds if falls through I’ll go down the list. Thank you