I'm looking for an ER11 x 5/16" collet for the SAC 7PRC sizing die mandrel. It's the only thing holding up my order from them. It looks like it's probably a custom size and can't find one from the usual sources like McMaster-Carr and MSC industrial. The largest size offered for ER11 is 1/4". Of coarse it was supposed to be instock when I placed the order. Got the rifle together but can't size brass. Any help finding a source for this piece would be appreiated.
SAC sizing Die Collet
- Thread starter axarob44
- Start date
Thank you very much!!!
ETA: Ended up ordering the Shars 5/16" ER11 collet from an Ebay seller for $17.99 ($11.77 from Shars) then my SAC 5/16" ER11 collet showed up. It is exactly the same collet. Shars 5/16" E11 collet from SAC. Unless the SAC collet has a better run-out spec a $32 ($38 from Shars) markup is a bit much for a collet. Maybe I'm wrong for posting this but that stings a little. So if the SAC sourced Shars collet has a TIR better than indicated on Shars website of .0003" then I'm sorry.
ETA: Ended up ordering the Shars 5/16" ER11 collet from an Ebay seller for $17.99 ($11.77 from Shars) then my SAC 5/16" ER11 collet showed up. It is exactly the same collet. Shars 5/16" E11 collet from SAC. Unless the SAC collet has a better run-out spec a $32 ($38 from Shars) markup is a bit much for a collet. Maybe I'm wrong for posting this but that stings a little. So if the SAC sourced Shars collet has a TIR better than indicated on Shars website of .0003" then I'm sorry.
Last edited:
Similar threads
Reloading Equipment
223 REM Dies SAC and RCBS
