Re: Sako TRG-22 Trouble
This from 338shooter might help:
<div class="ubbcode-block"><div class="ubbcode-header">Quote:</div><div class="ubbcode-body"> Proper adjustment procedures
1. Check that the weapon is free from cartridges and remove the bolt
2. Remove trigger unit as described in the user manual and clean it thoroughly.
3. Pull the safety on and adjust first stage pull weight against the safety to approx. 0.5-0.6 kg (small hex screw behind the trigger). Use loktite (222, 243 etc.)to prevent accidental loosening of the screw.
When you have the safety pulled on you can feel the actual first stage movement of the trigger before it comes in contact with the connector inside the trigger unit.
4. Assemble the trigger unit to the weapon. Never have the bolt in the weapon when assembling and tightening the trigger unit in place. If you have it in place it will immediately cause damage to the trigger unit when sear is forced down against the connector by the cocking piece of the firing pin and cocking surfaces/ corners on the sear and connector will break/crack.
5. Adjust the final pull weight to minimum of 1.0kg (hex screw in front of the trigger). Use loktite on the screw.
Always have sufficient gap in between first and second stage pull, first stage should be approx. half of the final pull weight (0.5/1.0kg, 0.6/1.2kg etc.). If the two weights are set too close the cocking corners will get rounded and the weapon will not stay properly cocked causing hard and long single stage pull like you described.
6. After adjusting the pull weight check the functioning of the safety.
Cock the rifle and pull safety on ->bolt handle will not come up and trigger will only move the first stage travel.
Push the safety off and dry fire the rifle. Try pulling the safety on -> safety should bounce back to the front position and not stay on. If the safety engages when rifle is not cocked the safety lever inside the trigger unit is worn or too loose and should be re-tightened properly. Have trained gunsmith do this!
Do not over lubricate the internal parts of the trigger unit; small amount of very thin synthetic oil or dry lube will do the trick. Two of the most common mistakes causing problems:
Improper adjustment of the first and second stage pull set too close to each other will wear the internal parts.
Assembling of the trigger unit to the rifle with the bolt in place will immediately break the internal parts.
Hope this helps and you'll get the trigger operational again?
If you're not able to adjust the trigger properly have the cocking corners in the trigger unit checked, they may be damaged already and the pull weight will not adjust properly...</div></div>
