Scope ring slightly hanging over rail

[Joko111]

I’m replacing the scope/rings on my .17 hornet, I am using seekins rings and the rear section of the rail only has 2 notches for ring placement, either way the ring hangs off slightly, I’d like to avoid getting a new rail or new rings but if this could potentially cause issues I’ll replace one or the other… the left side of the rail has full contact with the rear ring but the right is where the ring is hanging over

 

[Rob01]

It's fine. Especially on a little cartridge like that.

 

[Joko111]

It's fine. Especially on a little cartridge like that.

I figured so! Wanted to post anyways to get some input on it