Firearms Stainless Tikka, 6XC Barreled Action w/ Brass & Dies

[rothgyr]

Up for sale:

• Tikka T3 Stainless
• 6XC Criterion Barrel, shouldered by Solid Accuracy, 1:7.5 twist, MTU 26", exactly 600rds down the tube with mild loads (2930 fps or less)
• Mountain Tactical (Tikkaperformance) trigger spring
• Shortened Nightforce 20 Rail
• Sterk Bolt Handle
• Steel Bolt Shroud
• (Pictured brake IS NOT included)
• RCBS Match Master FL Sizing Die Set
• About 225 pieces of LRP Peterson brass (2x firings at very low pressures)

Some slight marring on the exterior of the barrel from using a wrench to get the brake off at a match. Scuffs on the bolt handle from typical match usage. I cut the Nightforce rail down a bit so I could reach under the bell of my scope and pick it up without grating my fingers. Tikka receivers are all long, so it's about the length of a standard R700 rail stil.

$1250 shipped to your FFL.

I have a couple of KRG Bravos (AICS and CTR) I can toss in, if you're looking for a reasonably priced chassis for it.

 

[rothgyr]

Bump

 

[rothgyr]

Bump