I have a walnut stock that is semi inlet for a Remington 700 short action, specifically it is for an USMC M40 clone. Any suggestions on who can finish the inletting?
DW
DW
Last edited:
Stock Inletting?
- Thread starter deltawiskey
- Start date
TS Customs inlets all their stocks on their CNC machines as well.
Not sure if they provide that service or only as part of their builds though.
Not sure if they provide that service or only as part of their builds though.
So, where the action sits is good?
Just needs the bottom done?
Have had bottom inlet work by LRI, Mile High, and Black Canyon Customs.
Would use any one of them again.
If you want the 1:1 3D mirror of your action topside, LRI does that for sure and a darn good job of it.
Or just grab a dremel…..
Just needs the bottom done?
Have had bottom inlet work by LRI, Mile High, and Black Canyon Customs.
Would use any one of them again.
If you want the 1:1 3D mirror of your action topside, LRI does that for sure and a darn good job of it.
Or just grab a dremel…..
