Hunting & Fishing T/C encore question
- Thread starter Nuttshooter
- Start date
Re: T/C encore question
This should be real easy.........take a look at this site, the variety & 200 calibers, so the answer is YES.
http://sskindustries.com/
xray9
This should be real easy.........take a look at this site, the variety & 200 calibers, so the answer is YES.
http://sskindustries.com/
xray9
Re: T/C encore question
<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: cruizer</div><div class="ubbcode-body">No
</div></div>
Correct - can't do 338 Lapua. Belted mag rim diameter (0.532") is about max, depending on chamber pressure. 338 WM and 338-06 are OK. I have one in 375 H&H....
Cheers,
Bill
<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: cruizer</div><div class="ubbcode-body">No
</div></div>
Correct - can't do 338 Lapua. Belted mag rim diameter (0.532") is about max, depending on chamber pressure. 338 WM and 338-06 are OK. I have one in 375 H&H....
Cheers,
Bill
Re: T/C encore question
I think you would stretch the frame with that. I know that is why you don't find some of the good calibers in the G2 like .308
I think you would stretch the frame with that. I know that is why you don't find some of the good calibers in the G2 like .308
Re: T/C encore question
Well I figured the parent case being 416 rigby and being able to get a factory barrel in 416 you would be able to run a 338 LM. Smith and wesson actually told me to see if someone would do it. They did not indicate there would be any safty issues.
I will look at SSK. Thanks
Ps. I know that pressures and angles are different. I was just hoping to be able to have a barrel made if no one makes one already.
Well I figured the parent case being 416 rigby and being able to get a factory barrel in 416 you would be able to run a 338 LM. Smith and wesson actually told me to see if someone would do it. They did not indicate there would be any safty issues.
I will look at SSK. Thanks
Ps. I know that pressures and angles are different. I was just hoping to be able to have a barrel made if no one makes one already.
Re: T/C encore question
Few years ago someone posted a pic of a RUM (forget which one 338 or 300) that ripped apart. That was a non-factory barrel, unk who the maker was, but it was on an encore frame FWIW.
Few years ago someone posted a pic of a RUM (forget which one 338 or 300) that ripped apart. That was a non-factory barrel, unk who the maker was, but it was on an encore frame FWIW.
Similar threads
