Target Stencils

jpistolero02

Sergeant
Full Member
Minuteman
Nov 9, 2008
299
21
45
Austin, TX
Does anyone have good suggestions for spraying center dots on steel plates? I have some plates of various sizes and thought there might be some good ideas for spraying center dots. I could always just cut some cardboard, but thought you guys might have better ideas.
 
I made myself some stencils out of 1/4” thick hardboard and a couple are plywood. They are about 14” wide and about 18” long. I drilled/cut a center hole representing 1 MOA at that distance. I have 3” for 300 yards, 4” for 400”, 5” for 500, etc.. I used them now for about 10 years and they are just as good as they were when I made them.
 
You must be at least 18 years of age to use this site
You confirm that you are at least 18 years of age by continuing to use the site.