Here they are, I had these rails made by Zermatt for clipon thermal usage. These are Cerakoted and use existing rail screws. They are made of aluminum and depending on the thermal, there is a support screw that can be used, just snug it to the barrel and back it off a 1/4 turn. These are 0 moa bases as well. The length is perfect for any 1-10 or shorter with the IRAY rh25 or voodoo S variant clipons. Not sure about the larger thermals as they use larger scopes too. It will work perfect with the NF 2.5-20 and TigIr clipon. My current setup uses NF 1-8 and either my Voodoo S or Iray Rh25. This is perfect for my shots up to 300yds and sometimes further.
Again, TL3 and Origin actions only, will not work with any others. Any requests for any of angles of my setups, I can send them. (The picture of the Side Chick is actually using the Ti3 action and rail, but I had a friend mill it for that chassis and I only had 2 of those rails made as the Ti3 is difference screw spacing from the TL3)
I'm $225 shipped each rail.
Again, TL3 and Origin actions only, will not work with any others. Any requests for any of angles of my setups, I can send them. (The picture of the Side Chick is actually using the Ti3 action and rail, but I had a friend mill it for that chassis and I only had 2 of those rails made as the Ti3 is difference screw spacing from the TL3)
I'm $225 shipped each rail.
