Gunsmithing TRG-22 Re-barrel Question

scotharr

Gunny Sergeant
Full Member
Minuteman
Jan 8, 2005
1,772
28
Scottsdale, AZ
Hi folks,

I have been asked to rebarrel a Sako TRG-22 with a Bartlein Heavy Palma barrel. I noticed that the factory barrel has a 1.160" shank versus the 1.250" shank on a palma barrel. Will a palma barrel fit into the Sako factory stock or should I turn down the shank to 1.160"? Unfortunately I do not have the stock to examine.

Thanks,
Scott
 
I recently re-barreled a TRG-22 with a medium Palma, I recall there would have been no issues going with a heavy when I discussed it with the smith. There is some clearance issues with a heavier barrel and the front sling stud mount on the left side, so you may need to remove it (it barely cleared the medium)
 
Huh. Posted an answer to this hours ago but I guess it didn't take...

It'll clear just fine. The 1.160" OEM barrel clears the stock by a minimum of ~.090" per side.

Hope that helps.