I cannot find the Sako manual to save my life. I ordered a badger ordnance 20 MOA base and rings from Eurooptic (who was awesome to deal with, even answered on a saturday!). Does anyone know what specs I should torque the base, and what specs I should torque the rings to? They will be mounting a NF NXS F1 mil/MLR2. If anyone could help this would be greatly appreciated! Thanks in advance!
Rifle Scopes TRG HELP
- Thread starter DeSnifter
- Start date
Re: TRG HELP
Here's badger's installation manual
http://badgerordnance.com/wp-content/plu...and%20bases.pdf
Base screws 15-18 in lbs.
1/2 nut 65 in lbs.
Here's badger's installation manual
http://badgerordnance.com/wp-content/plu...and%20bases.pdf
Base screws 15-18 in lbs.
1/2 nut 65 in lbs.
Re: TRG HELP
Torque it till it smokes, then back it off an 1/4 turn. LOL
I just looked at my manual and only shows their type of mount and does not give torque specs.
Just use good common sense(read, don't Gorilla fist it) and make sure they all are the same, short screws go to the front as well as use a dab of blue loc tite.
Enjoy.
SScott
Torque it till it smokes, then back it off an 1/4 turn. LOL
I just looked at my manual and only shows their type of mount and does not give torque specs.
Just use good common sense(read, don't Gorilla fist it) and make sure they all are the same, short screws go to the front as well as use a dab of blue loc tite.
Enjoy.
SScott
Similar threads
