• Cold Bore Ritual Contest - Only a Few Hours Left To Enter!

    What’s your cold bore ritual, that one thing you always do before your first shot to set yourself up for success? Winner gets new limited edition Hide merch. Remember, subscribers have a better chance of winning!

    Join contest Subscribe

Upper build

Medic08

Private
Full Member
Minuteman
Jan 11, 2004
19
0
Cokeburg, PA
So I'm looking to build an upper on an AR10 platform to bang steel out to 1k. Im looking for any advice. Im thinking 308 or 6.5cr. I would like to keep the barrel at 20". Im leaning to the 6.5. Any and all advice is accepted. I will be new to gas guns at distance.
 
Which Large Frame Lower ? I case you don't know, there are no meaningful "Mil-Spec" guidelines for Large Frame AR's .. so not every part is as "plug and play" as AR15's.

And ( IMHO ) a 6.5CM will be easier to shoot at 1K, less recoil, less drop and wind deflection then most 308 rounds.

An Adj. GB is a very helpful add-on, Dependent on your gas port size and / or location. Easier on the brass, you , follow up shoots, parts.. etc.

And... gas guns require more "training curve" at the bench then bolt guns... so plan on a decent amount of practice.
 
  • Like
Reactions: TACC
The 6.5 is definitely the better choice. I may even look at a 243 or 6xc in a ar10 platform if it’s for banging steel. I shoot a 260 and my wife has a 6xc going together. It’s hard to beat 6mm 115 dtac ballistics out to 1000 yards.
 
  • Like
Reactions: TACC
I have an Odin works 6.5 , 22 inch. It definitely is MOA as it says. Plus I was using American gunner 140 grain factory ammo.