I finally got my scope and rifle together and took them out for a shoot.
I was getting 1 3/4 inch groups at 100 yards with a new Savage FP10 ( 308) and a new millet 4x16 mil dot, mil rad set up.
I have the rifle on a laminate stock and was shooting 168 gn federal match ammo and I was shooting off of a lead sled.
I would expect this rifle to shoot better than that. I'm going back out on Friday or Saturday and was wondering if you guys have any ideas on what to look for to cure the vertical stringing.
I have the scope rails down pretty tight and the scope rings have been torqued with a fat wrench but I will be double checking the scope and rail set up again
I was getting 1 3/4 inch groups at 100 yards with a new Savage FP10 ( 308) and a new millet 4x16 mil dot, mil rad set up.
I have the rifle on a laminate stock and was shooting 168 gn federal match ammo and I was shooting off of a lead sled.
I would expect this rifle to shoot better than that. I'm going back out on Friday or Saturday and was wondering if you guys have any ideas on what to look for to cure the vertical stringing.
I have the scope rails down pretty tight and the scope rings have been torqued with a fat wrench but I will be double checking the scope and rail set up again