-
Having trouble using the site?
Contact support
Rimfire Vudoo V-22 V22 Single Shot Adapters AICS 22/SA and AR-10/15 Safety Blocks - 3D printed
- Thread starter KML7201
- Start date
Would like a Red Single-Shot adapter for Bergara. How do I order?
Why not go all out and make a nearly flush with the bottom metal magazine. The benchresters would love it. This rifle is a trend setter and there will be many new benchrest shooters on board. A redesigned magazine would look much better than the ugly factory magazine.
This would be especially true for those desiring a traditional wood replacement stock.
Reference from the top of the magazine, not the bottom.
From the rear of the magazine measure down 1 3/8 inches to the bottom of the magazine.
From the front of the magazine measure down 1 1/4 inches to the bottom of the magazine.
These dimensions will give nearly 1/8 inch clearance for the magazine release lug.
Understand that there will be programming and setup time involved but there will be a reduction in material cost and printing time.
Please review the dimensions and adjust as necessary to accomplish the flush fit magazine.
Appreciate your time and interest.
FritzFulton
This would be especially true for those desiring a traditional wood replacement stock.
Reference from the top of the magazine, not the bottom.
From the rear of the magazine measure down 1 3/8 inches to the bottom of the magazine.
From the front of the magazine measure down 1 1/4 inches to the bottom of the magazine.
These dimensions will give nearly 1/8 inch clearance for the magazine release lug.
Understand that there will be programming and setup time involved but there will be a reduction in material cost and printing time.
Please review the dimensions and adjust as necessary to accomplish the flush fit magazine.
Appreciate your time and interest.
FritzFulton
I'd like to buy a single shot adapter for a Bergara B14R if you have any. Let me know what to do. Thanks in advance, Terry
Similar threads
