Suppressors Which Suppressor

ZiaHunter

Sergeant
Full Member
Minuteman
  • Nov 25, 2012
    2,354
    4,369
    70
    Southern NM
    I have my trust setup and considering three different models which I plan on using on 6.5 CM and 300 WM bolt guns. They are as follows:

    Elite Iron Bravo
    AAC 300-TM
    Thunderbeast 30-P1

    Any thoughts/opinions?
     
    Go with the Titanium TBAC 30P-1.
    The Silencerco Harvester is Aluminum, and even though it's hard coat anodized, after some knocking around I wouldn't expect the finish to hold up as well.
     
    I have my trust setup and considering three different models which I plan on using on 6.5 CM and 300 WM bolt guns. They are as follows:

    Elite Iron Bravo
    AAC 300-TM
    Thunderbeast 30-P1

    Any thoughts/opinions?

    I have the 30P-1, myself. I can't address the pros and cons of the other two, because I have no exposure to them. They could be the best thing out there, for all I know.

    I've been running a Thunderbeast 30P-1 on my GAP .243 for some time now, and I have nothing but good things to say about it:

    IMG_1059.jpg


    Just last week, I had my Tubb T2K .308 barrel threaded for this suppressor. I sighted it in Monday and shot steel with it for the first time Tuesday:

    IMG_1339.jpg


    Both rifles are accurate, but they both seem to be even slightly more accurate with the suppressor aboard. Or, maybe I just am able to shoot them better with the suppressor mounted. And the 30P-1 only weighs a pound! Recoil is cut by an amazing amount, too. And of course, they're super quiet, especially the .308. I don't plan to fire a shot with either rifle unsuppressed ever again.