Hello all Got my XLR Chassis the other day put it all together and noticed that there was like half a millimeter of clearance between the scope and the tube.
Anyway today i was sitting back staring at the problem drinking a can of coke and had a brain fart y dont i just shim the part behind the orientation lug
so out come the tools and i have taken the tube off get the sheers and set about cutting a coke can up washing it and drying the piece that i wanted and installed four knotched pieces.
i found after installing these shim's u can variate how far away the tube is to the barrel or scope.
have yet to field test this but as far as i am concerned it worked a treat.
has anyone tried similar?
Anyway today i was sitting back staring at the problem drinking a can of coke and had a brain fart y dont i just shim the part behind the orientation lug
so out come the tools and i have taken the tube off get the sheers and set about cutting a coke can up washing it and drying the piece that i wanted and installed four knotched pieces.
i found after installing these shim's u can variate how far away the tube is to the barrel or scope.
have yet to field test this but as far as i am concerned it worked a treat.
has anyone tried similar?