XLR Element and Harris Bipod

[scwhit]

How are you guys attaching your Harris bipods to the element chassis? I bought a Harris mlok rotating adapter and realized it doesn’t fit all the way to the front, plus there is just a lot of “stuff “ up now.

After looking at some pictures of others I fear I may have over purchased haha.

 

[Kadams1563]

With a Pic rail lol.

 

[scwhit]

So a picatinny rail in the front most slot then a Picatinny rail Rotating quick detach Bipod Adapter?

Thanks for the help,

 

[MElank]

Why not just use the swivel stud that comes on the end of the Element chassis?

Or if you have adapted your Harris to work with a picatinny rail then XLR sells exact size pic rails that mount up to their holes in the end of their Element chassis.

 

[mi223]

I use the sling stud and factory harris mount with no complaints

 

[Nodakplowboy]

4" XLR pic rail on the chassis, ADM lever mounts on both the Atlas and Harris bipods. The ADM's let me swap out bipods throughout the rifle herd.

American Defense

 

[Ccollins02]

I used one of their short pic rail sections and my Harris bipods have ADM or Arisaka direct mounts.

 

[scwhit]

So you guys are using swivels bipods but no rotating?

 

[MtnCreek]

Swivel mount Harris to sling stud didn't snug up well on my evolution (round forend). I'm using an XLR rail section with Larue adapter.

If you buy a XLR rail section, I've had good experiences ordering from Red Hawk Rifles.

 

[scwhit]

Any particular swivel stud to fit up front? My element didn’t come with one.

 

[MElank]

I would bet if you called XLR and talked to Nick he may just send you one. Or let you buy the exact one that goes with that chassis for very cheap.

 

[Kadams1563]

I have one I can send you. PM me your address as long as I can find it.

 

[drwood96]

I used the swivel stud until I upgraded to an Area419 ARCA rail and RRS Harris adapter.

 

[scwhit]

Thanks for all the suggestions guys.

 

[Kadams1563]

It’s in the mail.

 

[scwhit]

Thank you so much, really appreciate it!

 

[Scott Thomson 9]

I have the same issue that I'm trying to work through. The rotating adapter attaches to the rifle with m-lok. I'd like to attach the m-lok rotating adapter to an ARCA clamp and putting a full length ARCA rail on the XLR Element chassis. Does anyone make a female M-Lok to female ARCA clamp?